State Water Heaters Hybrid Electric Heat Pump Water Heater User Manual (English)

Questions and Answers:

E
Elizabeth GonzalezAug 1, 2025
Why is there no hot water from my State Water Heaters Water Heater?
- J
  Jeremiah AndrewsAug 1, 2025
  Several factors can cause a lack of hot water. It could be due to high hot water demand exceeding the heater's capacity in the current mode; try changing the mode or adjusting your usage. Check if there's a blown fuse or tripped breaker, and restore power, then press the power button. Ensure the unit isn't in standby (press the power button) or vacation mode (select a different mode). The high-temperature limit switch might be open, requiring a reset (consult the 'Safety shut-off' section). Finally, a non-functioning upper temperature sensor could be the culprit, requiring professional service.
M
Mr. Jeffrey WoodAug 6, 2025
What to do if my State Water Heaters Water Heater has insufficient hot water?
- C
  Carmen SmithAug 7, 2025
  If you're experiencing insufficient hot water, there are several potential causes. First, check if the temperature set-point is too low and increase it. A dirty air filter can also cause this issue, so clean it. If your hot water usage exceeds the heater's capacity in the current mode, try changing to a different mode or modifying your usage patterns. Ensure the water connections are correct, with the cold connection at the bottom and the hot connection at the top. Insulate any exposed piping to prevent heat loss. Repair any hot water leaks. A non-functioning heating element may also be the cause, requiring professional service. Lastly, sediment or scale buildup in the tank can reduce efficiency; drain and flush the tank, and consider water conditioning to minimize future buildup.
H
hebertangelicaAug 13, 2025
How to reduce high operation costs of my State Water Heaters Hybrid Electric Heat Pump Water Heater?
- B
  Bethany HerreraAug 13, 2025
  To reduce high operation costs, consider these points: Ensure that the temperature set-point isn't too high. A dirty air filter can increase costs, so clean it. If the unit is in electric mode, switch to efficiency or hybrid mode. Verify that the water connections aren't reversed, ensuring the cold connection is at the bottom and the hot connection at the top. Insulate any exposed piping to minimize heat loss. Repair any hot water leaks. Finally, drain and flush the tank to remove sediment or scale buildup, and consider water conditioning.
S
Steven RiosAug 18, 2025
What to do if my State Water Heaters Water Heater temperature & pressure relief valve is dripping?
- J
  Jeffrey PerezAug 18, 2025
  A dripping temperature and pressure relief valve can indicate a few issues. Check the water supply inlet pressure; if it's higher than 80 PSIG, install a pressure reducing valve. Also, the issue may be related to the thermal expansion tank. Finally, the Temperature & Pressure Relief Valve may be non-functioning and require replacement.
B
Blake WilsonAug 25, 2025
Why my State Water Heaters Hybrid Electric Heat Pump Water Heater does not start immediately?
- A
  Andrea WalkerAug 25, 2025
  When first started, the water heater requires approximately 8 minutes to complete a diagnostic routine.