4
4
<S1> Rs232 Set.
This is used to set the baudrate of the Rs232.
Pressing the source key 1 the following visualization is obtained:
Baudrate=38400 <S1> 19200,n,8,1
<S0> 9600,n,8,1 <S2> 38400,n,8,1
The first communication up left is used to identify the current setting. The source keys
0,1 and 2 are used to set the new configuration of the serial port. The setting is valid
for both keyboards.
This function can only be used if the keyboard is unlocked.
Press the Menu key to exit when the choice is done.
<S2> Keyb.lock/Unlock
This option allows to lock or unlock the keyboard. If the keyboard is locked ( shown
on the display ) the only command accepted is unlock.
<S3>Preset Lock
This option allows to block or to enable the alteration of the cross points on a preset
(memory). This way important memories can be saved. In a blocked memory the
physical cross point can be modified, but not memorized. When the memory will be
recalled again no trace of that new cross point will be seen.
The blocked presets are shown with a - sign. A source key, from 0 to F, can be pressed
to modify the situation. Then press any of the destination keys to exit.
To Next Page
Loading...
General