CAMERA SETTINGS
PHOTO BURST: Choose how many photos are taken when the camera is triggered.
PIR DELAY: How long to wait before the camera can be triggered again.
PHOTO RESOLUTION: The quality of each image. A higher quality will result in
better photos and take more memory space.
REDUCE BLUR: Adjusts the MATRIX Blur technology to dramatically reduce the
blur effect, resulting in more clear night-time infrared shots.
STANDARD: Minimize blur, while keeping long-range night image capability.
ADVANCED: Enhance blur reduction providing a balance between brightness
and image sharpness.
PROGRESSIVE: Provides the sharpest photo with minimal blur, recommended
for well lit areas.
PIR SENSITIVITY: Control the camera range. Higher sensitivity allows further
range of detection. Note: Lower PIR sensitivity will reduce the occurrence of
False Triggers such as moving grass and tree branches.
CAMERA NAME: Give your camera a name to display on the Info Bar.
DVR MODE: This setting allows you to continuously record new images.
ON: continuously delete oldest recorded files to make space for new files.
OFF: stop recording new files when SD card reaches capacity.
OPERATING HOURS: Choose a specific timeframe for the camera to be active.
24/7: Camera is always on.
SCHEDULED: Enter a time range for the camera to take photos.
START TIME (HH:MM): Start time for camera to be active.
END TIME (HH:MM): End time for camera to be active.
ERASE CARD: Format the SD memory card. Formatting your SD card will ERASE
ALL DATA PRESENT. After card is formatted it is impossible to restore data
that was present on card.
To Next Page
Loading...
