CAMERA'PROGRAMMING'+'CU STOM'(CONT)'
PHOTO BURST – (1 Photo default): This setting is used to determine the number of photos the
camera will take during its activation. This setting can be changed between 1 PHOTO up to 3
PHOTOS. With this option blinking, use the UP or DOWN arrow key to move between the value
range in increments of 1. Press the ENTER button to accept all your changes and to go back to main
options menu. This setting is only visible in PHOTO MODE.
VIDEO LENGTH – (15 S default): This setting is used to determine the length of time, in seconds, of
the video recording. This setting can be set to either 30 S / 15 S / 10 S / 5 S. With this option
blinking, use the UP or DOWN arrow key to make your selection. Press the ENTER button to accept
all your changes and to go back to main options menu. This setting is only visible in VIDEO MODE.
DELAY – (5 S default): This setting is used to determine the length of time that the camera will
wait before it reinitializes its PIR sensor for the next activation. With this option blinking, use of the
UP and DOWN arrows to choice how many seconds you want the delay to be set for – 120 S / 60 S /
30 S / 15 S / 10 S / 5 S. Once this setting is on the appropriate time, press the ENTER button to
accept all your changes and to go back to main options menu.
RESOLUTION'–'(MED'default):!%8=3!31ZZ=?[!=3!931S!Z4!S1Z1:<=?1!Z81!M1[2>=J10!:13409Z=4?!4;!12X8!
=<2[1!Z2Y1?!d\!Z81!X2<1:2@!!%8=3!=3!4?0\!;4:!.j)%)!<4S1@!a=Z8!Z8=3!4>Z=4?!d0=?Y=?[T!931!Z81!UP!4:!
DOWN!2::45!Y1\!Z4!<4V1!d1Z511?!Z81!resolutions@!%81!8=[81:!Z81! :13409Z=4?! 4;! 2?! =<2[1! Z81!
<4:1! 3>2X1! Z81! ;=01! 5=00! Z2Y1! 4?! Z81! $_! <1<4:\! X2:S@! .:133! Z81! ENTER!d9ZZ4?!Z4! 2XX1>Z!200!
\49:!X82?[13!2?S!Z4
To Next Page
Loading...
Need help?
General
