Stealth 600 Gen 2 PS - No Mic Audio
The Stealth 600 Gen 2 PS headset has a flip-to-mute mic. When flipped all the way forward, the
mic is unmuted.
To mute the mic, flip it up and towards the back of the headset. There will be an audible tone
(low high) when the mic becomes muted.
Flip the mic to the second position shown in the following image to mute the mic as needed
during chats. Flip the mic to the third position in that image to mute the mic when it is not
needed.
If you are having issues being heard in chat, please do the following:
1. Make Sure Headset Is Charged/Powered On, Updated
First, charge the headset using its included USB Charge Cable. Then, make sure to hold the
Power button to power the headset on. Once the headset is powered on, update the headset's
firmware if you have not yet done so.
Once the headset is fully charged/powered on, and the headset's firmware is up to date, test the
headset again. Are you still having issues? If so, please move on to step 2.
2. Double-Check Headset is Paired To Transmitter/Detected By Console, Settings are
Configured
The headset and transmitter need to be paired in order to use the headset for chat. To make sure
the headset is paired to the transmitter, please disconnect the transmitter and power the headset
off completely. Then, perform the pairing process as indicated in this article -- but be sure to
connect the transmitter to a different USB port.
To Next Page
Need help?
General