$TäAl.TH
6. Insert the roller brush into the base of the brush, rotate the roller brush so that the brush can align with
the brush, meanwhile, make sure that the lock can align with the lock hole, then lock the roller brush.
5)
Filling up the Clean Water Tank
1. The cleaning water tank is located on the back of the main body. Grasp the top of the water tank with your
fingers and pull it upwards to remove it.
2. Unscrew the water cap counterclockwise as below and add some water, then screw it and insert the
clean water tank into the cleaner.
• Do not tighten the cover too tightly or too loosely, otherwise the cover may be damaged or the water
tank may leak.
• The user can also add some non-corrosive or flammable liquid cleaning solutions to clean the floor,
do not add dirty water to the cleaning water tank.
• It is normal if there is water in the water tank at the first use, tests and inspections are proceeded
before products leaving the factory.
info@altonindustries.com 09
To Next Page
Loading...