Steamfast SF-760 - Safe Use and Storage

4
|
ENGLISH
- When lling Water Tank, only water should be used in unit
- other cleaning agents could damage unit or cause injury.
Distilled or de-mineralized water is highly recommended, in
order to minimize potential build-up of mineral deposits. Do
not overll unit.
- Do not remove water tank cap during use. Allow unit to cool
completely before relling.
- Do not attempt to use steam function without properly lling
Water Tank.
- To reduce risk of contact with hot water emitting from steam
vents, check appliance before each use by positioning it away
from body and pressing Steam Burst Button. Do not operate
unit if steam vents are blocked.
- Do not allow power cord to touch hot surfaces (such as
Ironing Plate) during use. Store cord inside base.
- Always allow unit to cool completely (at least 30 minutes)
before storing. Place unit on base when cooling, to avoid heat
damage to surfaces.
- The iron must be used on a stable surface and rested on the
base when not in use.
- A loose t between wall outlet (receptacle) and plug may
cause overheating and distortion of the plug. Discontinue use
of the product in this outlet. Contact a qualied electrician to
replace loose or worn outlets.
- To reduce the likelihood of circuit overload, do not operate
another high wattage appliance on the same circuit.
- If an extension cord is absolutely necessary, a 15 amp rated
cord should be used. Cords rated for less amperage may
overheat. Care should be taken to arrange the cord so that
the cord cannot be pulled or tripped over.
- This appliance has a polarized plug (one blade is wider than