The display shows “donE” for some second to conrm that the program is correct-
ly saved. The product goes in the mode programmed for the current time and day of the week.
donE
Note:
-At any time you can abandon the procedure for viewing / editing the program deleting unsaved changes by
pressing the Stand-by button;
-During the programming the heating elements are disconnected and the product doesn't heat.
FROST FREE MODE
To activate the Frost free Mode hold the
key for 3’’. The thermostat is now set to maintain 7±3°C. To deactivate
the Frost free position just press the
or the button.
Frost free mode will activate automatically when no one has been detected for at least 36 hours. In this case,
the Comfort temperature will be automatically activated once a presence will have been detected.
3"
00
:
00
08
:
30
8. troubleshooting
• In the event of overheating, the safety device on the appliance automatically disabled the heating elements and
motor. In this case:
- Turn off the fan heater and allow it to cool down for about 15/20 minutes.
- Make sure the dust lter is not totally obstructed and clean if necessary. Remember to put it back again
afterwards.
- Eliminate any other possible reasons for overheating (e.g.: obstructions in front of the air inlet/outlet grilles,
build-ups of dirt).
- Turn on the fan heater again and check it works correctly.
• If the touch control commands are blocked or don't properly answer to digital pressure, turn off the heater using
the electromechanic switch on the left side of the heater. Then turn on the heater using the same switch.
9. Maintenance
• This product does not require any special maintenance.
• Clean the product with a dry cloth once every 6 months.
• If the product requires repairing, contact an authorised technical service centre.
• When replacing the power cable, use a 2x1,00mm2 H05VV-F HAR type. This operation must be performed
by qualied personnel and never by the end user in order to avoid damaging the appliance and jeopardising
personal safety.
To Next Page
