15
After approx. 1 minute, the display lighting (-50%) changes over to sleep mode to
save energy. As soon as you press a button, the lighting of the display returns.
Humidity
By pressing the Humidity button (setup flashes on the display) you can adjust the
humidity in a range from 45 to 90%. As soon as the device has reached the adjusted
humidity in the room, it is switched off. When the humidity drops below the adjusted
one, it is automatically switched on again.
Please note:
In the program Humidity, your air humidifier controls the water vapour automatically.
By means of the Max/Min button, you change the water vapour and so the quantity
of sprayed water.
1 - 9 bars are displayed at maximum. Consumption 30 watts
1 - 3 bars are displayed at minimum. Consumption 20 watts
Your air humidifier always starts with the medium program; 1 – 6 bars are displayed.
Consumption 25 watts
The percentage of water mist in a room and the air temperature are together the
relative humidity. The correlation between mist and air is varying at the different
temperatures. The higher the temperature is, the less water mist can be in the air.
In winter time the cold air comes from the outside and gets warmer by the room
temperature. The relative humidity is getting lower. The humidity must be increased
by a humidifier.
The relative humidity in a room should be:
bedroom or living room: 45-60%
sickroom: 40-50%
library: 40-50%
Heating (100 watts)
By pressing the button Heating (the Heating Symbol appears on the display), the
water is slightly pre-heated so that the water vapour of the room air does not with-
draw to much temperature. When you switch on Heating, 100 watts energy more are
consumed.
To Next Page
Loading...
