16
Pre-cleaning
Fill warm water into the jar (max. 1,2 l), add some detergent let
the device run by pushing the pulse-button.
Cleaning
∙ Unplug the device
∙ Never immerse the device into water
∙ Don’t let food dry up into the device, pay attention that no
food particles remain between the blades.
∙ Detachable parts of the device can be cleaned into the dish-
washer. Leave parts for drying.
∙ Don’t be too powerful while cleaning in order not to deform
the blades or the drive axle.
Usage:
∙ The appliance must not be plugged in during operation.
∙ Never try to insert the mixing insert without the jar into the appliance! Danger of
injury!
∙ Wipe the motor base with a damp cloth, rinse the jar and dry all parts.
∙ The complete assembled jar can be easily put on the motor base with a rotary
motion.
∙ Take care, that the mixing insert is always screwed tightly to the jar, else a leakage
can occur.
∙ When that happens, the appliance must be switched off and dried instantly.
∙ If liquid ran into the appliance, the appliance must be checked by an authorized
service person.
∙ By the first use, there might be a slight odor. This is normal and fades after some
use.
∙ Use the appliance only if completely assembled!
∙ The appliance must never be used without food or liquids.
∙ The jar and the lid must only be removed when the whole appliance fully
stopped.
∙ Do not fill liquids, hotter than 60°C in the cold jar, otherwise the jar may
break.
∙ Never overfill the jar to avoid splashes.
To Next Page
Loading...
