7.3 Temperature alarm
The temperature alarm helps to protect your cooled / frozen products and also
helps to save energy.
The alarm sounds when the internal space is not cold enough. The temperature
display flashes at the same time, or when too much warm air enters the cabinet
while sorting, placing, or removing food.
Pressing the "ALARM" button mutes the alarm. The temperature display contin-
ues to flash until the alarm state is over.
8 Menu functions
The following functions can be set using the menu:
The display brightness
Temperature display in degrees Celsius or Fahrenheit
The use of the device as a refrigerator or freezer
8.1 Setting the brightness
Pressing the ➏ button (Menu) for 3 seconds brings you to the menu, the ➎
display (°F symbol) flashes and "b" is displayed.
Pressing the ➏ button (Menu) again causes a "1" to appear in the display.
The ➊ buttons (Up / Down) allow a brightness value of 1, 2 or 3 to be
selected. The higher the number, the brighter the display.
Once the desired brightness has been set, this has to be confirmed by
pressing the ➏ button (Menu).
Pressing the ➋ button (On / Off) returns you to the standard mode.
NOTE
Energy saving
The higher the brightness, the higher the power consumption.The factory setting
b1 is the power-saving mode.
8.2 Setting the display of Celsius / Fahrenheit
Pressing the ➏ button (Menu) for 3 seconds brings you to the menu, the ➎
display (°F symbol) flashes and "b" is displayed.
Pressing the ➊ button (Up) allows you to change from "b" to
.
If you now press the ➏ button (Menu) then °C appears.
The ➊ buttons (Up / Down) can now be used to select between °C and °F.
Once the desired value has been set, this is confirmed by pressing the ➏
button (Menu).
Pressing the ➋ button (On / Off) returns you to the standard mode.
8.3 Setting refrigerator / freezer mode
Pressing the ➏ button (Menu) for 3 seconds brings you to the menu, dis-
play 5 (°F symbol) flashes.
Pressing the ➊ button (Up) causes
to appear.
Pressing the ➊ button again causes F to appear.
Pressing the ➏ button (Menu) again causes F
to display.
The ➊ buttons (Up / Down) can now be used to select between refrigerator
F
and freezer F
.
Once the desired value has been set, this is confirmed by pressing the ➏
button (Menu).
Pressing the ➋ button (On / Off) returns you to the standard mode.
•
•
•
11
22
33
44
11
22
33
44
55
11
22
33
44
55
66
Refrigerator
Freezer
To Next Page
Loading...
Need help?
General