Steeda S550 - Securing with Push Pin; Final Tightness Check

2. By bending and reaching behind the wheel liner, line up the bracket with the factory
valance hole. (Figure 7)
3. Fasten the splitter to the factory valance with the nut and bolt and then secure
everything into place with a push pin.
Figure 7 Figure 8
!
4. Lastly, check to ensure that all of the bolts and push pins are tight.
2015 S550 Front Splitter (283-S550-GT-PP)
!
3/18/2015
© 2015 Steeda Autosports, All Rights Reserved.