Steeda S550 User Manual

Removal of the factory belly pan:
1. Raise and support the vehicle.
2. Remove all 7mm bolts and push pins that are securing the belly pan to the chassis.
(Refer to Figure 1)
3. Keep these extra bolts and push pins from the belly pan so that they can be used to
install the front splitter. (Figure 4)
Figure 1 Figure 2
2015 S550 Front Splitter (283-S550-GT-PP)
!
3/18/2015
© 2015 Steeda Autosports, All Rights Reserved.

Steeda S550 Specifications

General

Brand	Steeda
Model	S550
Category	Automobile Accessories
Language	English

Summary

Removal of Factory Belly Pan

Remove Belly Pan Fasteners

Remove 7mm bolts and push pins securing the belly pan to the chassis.

Retain Belly Pan Hardware

Keep removed bolts and push pins for installing the front splitter.

Installing the Front Splitter

Positioning and Initial Fastening

Center splitter, align brackets, and loosely fasten nuts and bolts.

Securing Splitter to Chassis

Tightly secure all bolts after centering and aligning the splitter.

Making Splitter Flush with Valance

Drilling for Flush Fitment

Drill holes through splitter and valance to eliminate gaps for a flush fit.

Repeating for Opposite Side

Repeat the drilling process on the opposite side for symmetrical flushness.

Fastening Splitter to Factory Valance

Attaching Bracket to Valance

Use a bracket, bolt, and nut to fasten the splitter to the valance.

Securing with Push Pin

Fasten the splitter to the factory valance using a nut, bolt, and push pin.

Final Tightness Check

Check that all bolts and push pins are tight after installation.