Steeda Tri-Ax - Shifter Arm to Base Assembly; Rear Shifter Mount Assembly; Shifter Installation to Chassis; Rear Shifter Mount Attachment to Chassis

2. The shifter ships in two pieces, an Arm and a Base. Attach the arm to the base with the provided Socket Head Cap
Screws.
3. Assemble the rear shifter mount. Sandwich the rear hole in the shifter with the two provided urethane bushings.
Then insert the flanged tube from the top with the round edge facing forward. Bolt the assembly together as shown
using large washer, then the lock washer, and provided hex bolt.
4. Fit the new Tri-Ax shifter into the opening in the chassis and attach the transmission arm to the transmission using
the factory bolt removed in Step 5.
5. Attach the rear of the shifter to the factory studs on the chassis using the nuts removed in Step 6. Picture 7