6. Grease the u-shaped bracket and insert it over the bottom of the shift lever. The wider side should be placed
towards the drivers side of the vehicle. Reuse the nylon bushings from the stock unit as shown. Picture 8
7. Grease the nylon bushings and insert the factory shift rod, driver's side first, and temporarily reinstall the factory
nut removed in Step 4.
8. Set the Shifter Stops as Follows Make sure all adjustments are done at this time. From inside the car you
must adjust the shifter stops:
9. Back off the stop bolts so that the shifter moves freely into all gears
To Next Page
Loading...
