the engine will automatically stop. If you attempt to start the generator
without addressing the problem, the unit will not start. When the "low oil"
light illuminates, check the oil level first to make certain that there is
adequate oil in the reservoir.
Do not adjust either the engine governor bolt that controls engine speed or
the fuel injection bolt that controls fuel mix. Doing so will affect the overall
performance of your generator.
5.2 Operational System Checks
• Determine whether there is abnormal sound or vibration
• Determine whether the engine misfires or runs rough.
• Examine the color of the exhaust. If it is too black or too white, shut off your
generator.
Caution:
• If your generator has been in operation, the muffler will be extremely hot. Do
Not touch the muffler as you can be severely burned.
• Never refill the fuel tank while the engine is running.
6. Your Generators Capacity
Caution
• Do not attempt to start two or more devices simultaneously. First plug in or
start one device, then the next, and then the next.
6.1 AC application
• Make certain that you operate the generator at its rated speed in RPM's. If
this is not done, the AVR or Automatic Voltage Regulator will incorrectly
produce too much voltage shortening the life of the AVR.
• After switching on the circuit breaker, check the voltmeter on the control panel.
The voltmeter should point to 120V +/- 5% for a single phase generator and
230V +/- 5% (50 Hz) for a multiphase generator.
10
To Next Page
Loading...
Need help?
General
