Steepletone BROMLEY - User Manual

Questions and Answers

V
Vanessa JensenJul 31, 2025
What to do if there is no power to my Steepletone BROMLEY?
- J
  James AvilaJul 31, 2025
  First, ensure the DC power lead single pin plug is fully inserted into the DC socket on the rear of the unit, and the 3pin plug into the AC power socket. Next, check the wall socket is working by plugging in another device, and ensure the wall socket switch (if any) has been switched on. Finally, make sure the unit is switched on with the ON-OFF Switch.
B
Brett SmithAug 4, 2025
Why is there no sound coming from my Steepletone BROMLEY Stereo System?
- M
  Mark ScottAug 4, 2025
  If you're not getting any sound from your Steepletone Stereo System, try the following: * Increase the volume level by turning the Volume Control. * Check that headphones are not plugged in, as this will cut sound from the speakers. * Ensure the Play/Pause button hasn't been pressed accidentally; press it to resume play. * Make sure no external device or cable is connected to the LINE-IN jack. Remove it before using another function.
B
Brittany BassAug 8, 2025
Why won't the turntable work on my Steepletone BROMLEY?
- A
  Angela SummersAug 8, 2025
  If the turntable on your Steepletone Stereo System isn't working, first ensure the unit is set to Phono mode by sliding the Function switch to ‘AUX/PH’. Then, move the Tone arm toward the turntable platter - it should start rotating. Finally, if the platter revolves freely when spun manually, the Turntable Drive Belt may have become disconnected in transit and needs to be refitted.
V
Vanessa FrancoAug 12, 2025
What to do if the CD does not play on my Steepletone Stereo System?
- Z
  zsmithAug 13, 2025
  If your CD isn't playing on your Steepletone Stereo System, check the following: 1. Ensure the CD is correctly placed on the CD mechanism with the label side facing up. 2. Make sure the Function switch is set to CD and a Disc is in the tray. 3. Verify the CD is not blank and has music recorded on it. 4. Check that the surface of the CD is clean. 5. Note that you can’t play unfinished CD-Rs / CD-RW / CD-MP3-CDs. Finish those CDs in a CD recorder and then try again.
B
Brian LongAug 17, 2025
What to do if the tone arm will not move on my Steepletone Stereo System?
- A
  Angela McfarlandAug 17, 2025
  If the tone arm on your Steepletone Stereo System won't move, check that the black tie-wrap has been removed from the Tone Arm and that the Tone Arm hold down clip has been released to the right. Also, make sure you lift the Tone Arm with the Cue Lever and then move it manually over the edge of the record – then lower it with the Cue Lever.
L
Lisa FosterAug 21, 2025
What to do if the tone arm slides or skips across the record on my Steepletone BROMLEY?
- B
  barnettcoreyAug 21, 2025
  If the tone arm on your Steepletone Stereo System slides or skips across the record, ensure the protective needle cover is removed. Also, make sure the Stylus has not been damaged or is worn out – replace if necessary. Use no scratched, damaged or twisted records, and clean the records before use. Finally, make sure the unit is placed on a level and stable surface to avoid vibrations or shock.
L
Lindsey BlakeAug 26, 2025
Why is the turntable sound low when playing a record on my Steepletone Stereo System?
- J
  John SullivanAug 26, 2025
  If the turntable sound is low when playing a record on your Steepletone Stereo System, try removing and refitting the stylus and/or Tone Arm Cartridge. You can also try turning up the volume a bit more.