2
IDENTIFY HEATER TYPE
Determine the type of heater:
•
•
Determine the method of peak control being
used. This will determine what controls are
required, and how the heater will be installed
and programmed.
•
•
•
•
Sample Unit Identication Label
DETERMINE INSTALLATION LOCATION
(PLACEMENT AND CLEARANCES)
WARNING
Risk of re. Can cause injury or death.
Violation of the clearance requirements can
cause improper operation of the equipment.
Maintain the placement and clearance
requirements specied.
*
is recommended to ensure accurate room temperature sensing. The
servicing.
3
4
NOTE: Special requirements must be considered
if placing the heater in a garage or other
area where combustible vapors may
be present. Consult local, state, and
national codes and regulations to ensure
proper installation.
There are minimum clearances that must be considered
when choosing a location. These areas surrounding the
heater must be kept open and free of debris. Verify the
heater.
MINIMUM CLEARANCES:
A Top = 4 inches
B
C Sides = 2 inches
*
D
Model
Installed
Weight (lbs)
# of
Brick
Pkgs
2102PI 281 8
To Next Page
Loading...
