Steinbach 060055 - Operation; Checking the delivery for completeness and damage; Initial cleaning of the product; Inserting or changing batteries

-
In the case of damage, substitute the packaging with an at
least similar box.
Checking the delivery for completeness and damage
1. Open the packaging carefully.
2. Take all parts out of the packaging.
3. Check the completeness of the delivery.
4. Check the delivery for damage.
Initial cleaning of the product
1. Remove the packaging material and all protective foils if present.
2. Clean all parts of the delivery as described in the "Cleaning" section.
The product has been cleaned and prepared for use.
Operation
NOTICE!
Water or other liquids may cause the batteries to short-circuit in
the battery compartment.
-
Make sure that neither water nor other liquids enter the
battery compartment.
Inserting or changing batteries
1. Open the housing by unscrewing the light dome
3
counter-clockwise from the bottom
part
2
.
2. Pull the battery compartment cover
4
upwards and off the battery compartment
5
.
3. Remove the spent batteries.
At delivery there are no batteries in the battery compartment.
4. Insert 3 new AA batteries.
Always exchange all batteries. Never mix batteries with different charge levels. Use
only batteries that are listed in the "Technical Data" section.
5. Close the battery compartment cover
4
.
6. Close the housing by screwing the light dome
3
clockwise onto the bottom part
2
.
Make sure that the housing is tightly closed and thus leak-proof.
If you are not using the light show for longer periods, remove and store
the batteries separately to extend their service life.
17