Steinbach BP-39WS-B Mini - Display; Standby mode

Connecting the lines
Establishing the power supply
The MINI heat pump cannot be operated with an external mer and must be switched
on/o via the RCD adapter.
1. Connect the RCD adapter
C
to the voltage supply set up at the installaon site.
The power supply has been established.
Connecng a drain hose for condensate (oponal)
1. Insert the drain spout
4
into the hole in the base plate.
2. Aach the drain hose (garden hose) for condensate to the drain spout
4
.
The drain hose for the condensate is connected.
Display
Standby mode
When in Standby mode, the heat pump is operaonally ready but deacvated. Pressing
the On/O buon
15
switches the heat pump into the Operate mode.
Aer being switched on, the heat exchanger must rst warm up before the
heat pump is ready for operaon in the Operate mode. This process can take
up to 90 seconds.
Display:
- The Display
14
shows the word “OFF”.
Operating mode
In operang mode the heat pump heats the water up to the set water temperature. The
standard value for the set water temperature is 27°C. The set water temperature can be
between +15°C and +35°C. The heat pump switches into standby mode by pressing the
Set
G
14
15
52