Steinbach Classic 310 - Before First Use; Check Before Start-up; Preparing the Filter Vessel

1. Switch the pump
3
o by pulling the
power plug.
2. Press and hold down the valve lever
31
on
the valve head
1
.
3. Set the valve lever to the "FILTER" posion
and release it.
In the case of very dirty water, you can
select the "WASTE" mode alternavely
(see secon "Modes").
The oor cleaner is connected to the lter system.
Before First Use
Check the following before start-up
1. Make sure that the pump's power cable is disconnected from the power supply.
2. Make sure that the device is located outside the pool and below the water level.
3. Make sure that all feed and drain lines are correctly connected and fastened in place.
4. Make sure that the pool's water level is at least 2.5 to 5 cm above the opening of the
sucon line. If this is not the case, top up the pool.
5. Remove the stopper on the sucon line if applicable.
6. Open the shut-o valve on the sucon line.
The lter system lls automacally with water because it is below the water level.
Preparing the filter vessel
1. Undo the locking ring
7
by turning the
screw counter-clockwise. Use the Allen
wrench
22
for this purpose.
2. Put aside the locking ring and its screws.
3. Mount the drainage screws set
11
on the
drainage opening
24
.
2
3
50