Steinbach Classic 310 - Selecting the Mode; Pump Operation; Pump Operation with External Timer; Care Instructions

Selecting the mode
1. Switch the pump
3
o by pulling the
power plug.
2. Press and hold down the valve lever
31
on the valve head
1
.
3. Turn the valve lever to the desired
posion and let go.
The level engages at that posion.
The desired mode is set.
Pump operation
Starting the pump operation
Check the valve seng of your lter system before you acvate the pump.
1. Connect the pump's power plug to the power supply.
The pump is running. Listen to the pump to check for any unusual noises. If there is air in
the system, bleed it again.
Stopping the pump operation
Pump operaon is ended by unplugging the power plug.
Pump operation with an external timer
The pump can be operated in intervals with the aid of an external mer (not included in
the package contents).
1. Connect the mer to the power supply and set the desired running mes.
2. Connect the pump's power plug to the mer.
The mer now controls the running mes of the pump.
Care instructions
The lter system cannot lter out algae, bacteria and other microorganisms.
- Use special water care substances to prevent and remove these to ensure
hygienically clean water.
- Consult an expert and observe the dosage.
19
57