Steinbach Classic 310 - Connecting the Backwash Line; Preparing the Filter System

1. Screw a hose adapter
21
clockwise
onto the prelter cover
4
.
2. Make sure that water from the supply
or drain line does not ow into the
pool.
3. Push the hose end onto the hose
adapter and use the hose clamps to x
the hose in place.
The sucon line is connected.
Connecting the backwash line
A rubber stopper is inserted in the "WASTE" connecon at the factory. You
can leave this stopper in, if you are not using the backwash line (e.g. when
using lter balls as lter medium), to protect the device from dirt and insects
entering the system.
1. Pull the rubber stopper out of the "WASTE" connecon in the valve head
1
.
2. Connect one end of the hose to the "WASTE" connecon.
3. Guide the second hose end towards the channel connecon.
The backwash line
30
is connected.
Preparing the filter system
1. Press and hold down the valve lever
31
on the valve head
1
.
2. Set the valve lever to the "BACKWASH" posion and release it.
3. Allow the lter vessel
2
to ll with water unl the water runs out of the "WASTE"
backwash line
30
.
4. Check the lter system and the connecons for leaks.
In the case of leaks, wrap extra Teon tape
23
around the aected connecons.
5. Backwash the system (see secon "Backwashing").
Operation
CAUTION!
Risk of injury!
A damaged device or damaged accessories may cause injuries.
- Check the device and the accessories (see secon "Tesng").
18
21
4
56