Steinbach Classic 310 - Winter Storage; Cleaning

9. Inside the lter vessel, pull the lter arms
9
o the screen
8
.
10. Remove the screen.
11. Thoroughly rinse the screen and the lter arms under owing water.
12. Rinse the lter vessel with clean water.
13. Carry out steps 4 to 12 as described in the "Preparing the lter vessel" secon.
The lter medium is exchanged.
Winter storage
1. Switch the pump
3
o by pulling the power plug.
2. Close the shut-o valves or block the water ow to the pool's connecng hoses.
3. Uninstall the connecng lines to the pool and drain the hoses.
4. Loosen the drain screws
33
on the pump housing and completely empty the pump.
5. Remove the lter medium (see "Exchanging the lter medium" secon).
If you are using lter balls, wash them by hand and let them dry completely.
6. Store the lter medium separately. It must not be stored in the lter vessel.
7. Rinse the lter system with tap water.
8. Let the lter system dry completely.
9. Press and hold down the valve lever
31
on the valve head
1
.
10. Turn the valve lever to the "WINTER" posion and let go.
The device can be stored over the winter.
Cleaning
NOTICE!
Improper cleaning might damage the device.
- Clean the surface of the device with plain water aer each use.
-
Do not use any aggressive cleaning agents.
- Do not use any sharp or metal objects such as knives, hard
scrapers or similar.
- Do not use any cleaning brushes.
- Do not use a high-pressure cleaner.
59