Steinbach Classic 310 - Test; Storage; Troubleshooting

Test
Check the following before each use:
- Is there visible damage on the device?
- Is there visible damage on the control elements?
- Are the accessories in perfect condion?
- Are all lines in perfect condion?
- Is the feed unblocked?
- Are the venlaon slots clear and clean?
Do not start up a damaged device or damaged accessories. Have them checked by the
manufacturer or its customer service or a qualied service technician.
Storage
1. Thoroughly clean the device (see secon "Cleaning").
2. Remove all lines, the pump and the lter vessel.
3. Let the device dry completely aer cleaning.
4. Store the device in a dry and frost-free locaon (>= +5 °C) without direct sunlight.
Troubleshooting
Problem Possible cause Remedy
The pressure on the
manometer exceeds 1 bar.
The quartz lter sand is
dirty.
Backush the system (see
"Backushing" secon).
The lter balls are dirty. Remove and wash the lter balls by
hand. Exchange the lter balls if
necessary.
Air bubbles escape from the
injecon nozzle.
The pump is sucking in air. Check all hoses and seals for leaks.
Reghten the hose clamps.
The pump is not geng
enough water or the system
pressure is too low.
The water level in the pool
is too low.
Raise the water level in the pool.
The prelter basket (if
available) is clogged.
Empty the prelter basket.
The sucon line is clogged. Clean the pressure line.
The pump does not start up. The pump has no power. Connect the pump's power plug to
the power supply. Check whether
the fuse has triggered.
The pump is defecve. Contact customer service.
60