Setting the desired water temperature
1. Repeatedly press the Up16 or Down17 button.
The display
14
shows the desired water temperature in °C.
The heat pump does not work if the set desired water temperature is below the
measured current water temperature.
Displaying or setting parameters
The heat pump has 11 parameters which can be shown or set via the display D (see
“Parameters”).
Displaying the parameters
1. Press and hold the SET button 18 for 5 seconds while the heat pump is in the Operate mode.
The display
14
shows “A”.
2. Press the Up 16 or Down 17 button repeatedly.
The display
14
shows the selected parameter (A, B, C, 1-8; see “Parameters”).
3. Press the SET button 18 to select the required parameter.
The value of the selected parameter blinks on the display
14
.
Setting the parameters
1. Press the Up 16 or Down 17 button repeatedly.
The desired value of the selected parameter blinks on the display
14
.
2. Press the SET button 18.
The desired value of the selected parameter is now set.
Deinstallation
CAUTION!
Risk of injury when moving heavy equipment!
The device is heavy! Incorrect lifting or uncontrolled tipping of the device can
result in injuries or damage to the device.
-
Only lift, carry or tip the device with two people, never alone.
-
Pay attention to maintaining proper posture (straight back, secure footing,
etc.).
-
Use transport aids (e.g. pallet truck, or creeper dolly).
-
Wear protective equipment such as safety footwear or gloves.
Disconnecting the supply lines
Disconnecting the electrical
1. Put the heat pump into the Standby mode (see the chapter on “Display”).
2. Press the RESET button
12.
3. Disconnect the RCD adapter
C from the electrical supply.
The heat pump is now disconnected from the electrical supply.
Disconnecting the water lines
1. Switch off the water treatment pump.
41
To Next Page
Loading...
