Steinbach Poolrunner - Starting cleaning; Switching off the device

2. Connect the plug of the oang
cable
1
in the right posion to the
control unit
5
and screw the
connecon together.
3. Aach the control unit
5
at a distance
of at least A=3.5 m to the pool with the
safety rope
7
so that it cannot be
pulled into the water.
4. Connect the power plug to a grounded
socket.
The control unit is connected.
Starting cleaning
1. Press the ON/OFF buon
12
.
The device starts moving. The indicator
10
of the last selected cleaning cycle starts to
blink.
To change the cleaning cycle, press the CYCLE buon
11
.
It is normal that the device knocks against the pool wall. You can adjust the
speed of the device with the two nozzles, see secon "Basic sengs".
Cleaning stops automacally at the end of the set cleaning cycle. All indicators
10
blink.
Switching off the device
Proceed as follows to switch o the device:
11
1
5
12
A
5
7
13
5
10
12
11
41