EasyManuals Logo

Steiner DBAL-I2 User Manual

Steiner DBAL-I2
80 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #57 background imageLoading...
Page #57 background image
56
4.1.b Explanation of Table Entries
1. Item Number
Numbers in this column are for reference. Item numbers also appear in the
order that you must perform the checks and services listed.
2. Interval
This column tells you when you must do the procedure in the procedure
column. BEFORE (B) PROCEDURES must be done before you operate or use the
equipment. DURING (D) PROCEDURES must be done during the time you are
operating or using the equipment. AFTER (A) PROCEDURES must be done
immediately after you have operated or used the equipment.
3. Item to Check/Service
This column provides the item to be checked or serviced.
4. Procedure
This column gives the procedure you must do to check the item.
5. Not Fully Mission Capable If
Information in this column tells you what faults will keep your equipment
from being capable of performing its primary mission. Be sure to observe all
special information and notes that appear in your table.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Steiner DBAL-I2 and is the answer not in the manual?

Steiner DBAL-I2 Specifications

General IconGeneral
BrandSteiner
ModelDBAL-I2
CategoryMeasuring Instruments
LanguageEnglish