Steiner DBAL-I2 - User Manual

Questions and Answers

C
Charles FloresJul 28, 2025
What to do if the POINT beam cannot be zeroed to the weapon on Steiner DBAL-I2 Measuring Instruments?
- Z
  zimmermanjamesJul 28, 2025
  If the POINT beam on your Steiner Measuring Instruments cannot be zeroed to the weapon, first ensure that the Quick Release Mount is correctly positioned and secured. If the laser is loose on the rail, try repositioning it on a different part of the rail or moving it to a different rail altogether. Replacing the rail on the weapon might also help. Also, check the mount base for any corrosion or dirt and clean it as necessary. If the problem persists, notify Unit Maintenance.
D
derek60Aug 3, 2025
Why are the POINT/ILLUM beams weak on my Steiner Measuring Instruments?
- R
  ryan76Aug 4, 2025
  If the POINT/ILLUM beams on your Steiner Measuring Instruments appear weak, ensure that the Exit Port Cover is removed and the Exit Port Lens isn't obscured by mud or dirt; clean the lenses if needed. Also, verify that the battery is installed correctly and tighten the battery cap or install a new battery. If the Exit Port Lens is scratched or pitted, notify Unit Maintenance.
B
Bridget AlvarezAug 10, 2025
What to do if POINT/ILLUM beams fail to come on in Steiner Measuring Instruments?
- C
  Charlene WalshAug 10, 2025
  If the POINT/ILLUM beams on your Steiner Measuring Instruments fail to activate or stay on, inspect the battery contact spring in the battery compartment for damage or corrosion. If there's damage or corrosion or a possible internal failure, notify Unit Maintenance.
T
Travis JimenezAug 16, 2025
How to fix POINT/ILLUM beams that do not move on Steiner Measuring Instruments?
- C
  Cheryl EvansAug 16, 2025
  If the POINT/ILLUM beams on your Steiner Measuring Instruments do not move, verify the adjuster function and clean as required. If this doesn't solve the issue, notify Unit Maintenance. Also, check that the Remote Cable Switch plug is fully seated; reconnect it and flush with water if necessary.
L
Leslie NelsonAug 21, 2025
Why ILLUM knob turns, but beam does not change on Steiner DBAL-I2?
- I
  Ivan MurrayAug 21, 2025
  If the ILLUM knob on your Steiner Measuring Instruments turns but the beam doesn't change, make sure the knob is free of mud and dirt. Clean it as required. If the problem persists, notify Unit Maintenance.