72
5.3 TESTS AND INSPECTIONS
See Preventive Maintenance Checks and Services Table 4-1.
5.4 REMOVAL AND REPLACEMENT OF PARTS
Unit Maintenance is authorized for the removal and replacement of a limited
number of assemblies. All repair parts can be installed at the unit level.
Special tools or equipment are not required for maintaining the DBAL-I
2
.
5.4.a Battery Removal and Installation
See Chapter III, Paragraph 3.2.a for procedures.
5.4.b Remove and Replace Battery Cap
To remove, stretch the end of the Retaining Strap over the stud on the Battery
Cap. Unscrew the battery cap in a CCW direction. Install new battery cap and
hand tighten in a CW direction. Reattached strap by stretching the end over
the stud located on the battery cap.
5.4.c Removal and Replacement of Battery Cap Retaining Strap
NOTE
Install the Battery Cap Retaining Strap below the Exit Port Cover Retaining
Strap on the IR ILLUM.
To remove the Battery Cap Retaining Strap it is necessary to remove the Exit
Port Cover Retaining Strap first.
To Next Page
Loading...
Need help?
General