73
To install, stretch the end of the retaining strap over the stud located on the
battery cap. Stretch the other end of the strap over the stud located below
the IR ILLUM focusing assembly.
To remove, stretch the end of the Strap over the stud on the Battery Cap then
stretch the other end over the stud below the IR ILLUM.
5.4.d Remove and Replace Battery Cap O-ring
NOTE
NEVER use a sharp or metal object to remove O-rings as they may damage
the O-ring or the O-ring groove contact surface.Inspect the O-ring for nicks,
cracks, cuts or abrasion. Also check to make sure that it feels soft. If
damaged, replace the O-ring.
To remove pull the O-ring out of the groove at the base of the threaded
portion of the battery cap and remove. Install the new O-ring by pulling it
onto the battery cap so that it fits in the groove located at the base of the
threaded portion of the battery cap.
5.4.e Remove and Replace Safety Screw
WARNING
In order to make the DBAL-I
2
operate in the High Power modes of operation
the blue Safety Screw must be removed from the back of the unit. The
Armorer will remove and store the Safety Screw.
To Next Page
Loading...
Need help?
General