74
CAUTION
DO NOT over tighten the Safety Screw as it may strip the threads in the housing.
The Armorer will remove and store the Safety Screw using a 3/32 in. hex key.
The Armorer will install the Safety Screw using a 3/32 in. hex key.
5.4.f Removal and Replacement of Exit Port Cover Retaining Straps
To remove the top Exit Port Cover, pull on the loose end of the Exit Port Cover
retaining strap and stretch it over the top stud. Repeat the procedure to
remove the bottom Exit Port Cover retaining strap from the DBAL-I
2
.
To replace the Exit Port Cover Retaining Straps, stretch the end of the retaining
strap over the retaining stud located on the bottom of the housing. Repeat the
procedure by stretching the loose end of the retaining strap over the stud
located on the top of the housing.
To Next Page
Loading...
Need help?
General