WARNING
Be sure the weapon is CLEAR and on SAFE before proceeding.
WARNING RISK OF DETECTION BY ENEMY
To reduce the risk of detection by an enemy using a Night Vision Device
(NVD), avoid prolonged activation of the DBAL-I
2
.
The infrared beam is more detectable to an enemy using a NVD when used in
smoke, fog and rain. Avoid prolonged activation of the DBAL-I
2
in these conditions.
WARNING
DO NOT store the DBAL-I
2
with the battery installed.
WARNING
The High Power Modes are blocked with a safety screw.
WARNING
To operate the DBAL-I
2
in the High Power modes the blue safety screw must
be removed from the back of the unit. The Armorer will remove and store the
safety screw.
WARNING
All directions, such as CW and CCW, are given from the shooter’s point of
view, as though the DBAL-I
2
were weapon-mounted.
WARNING
The DBAL-I
2
is powered by one 3-volt CR 123A Lithium Manganese Dioxide
(Li/MnO2) battery. The following safety precautions apply when handling
lithium batteries:
4
To Next Page
Loading...
Need help?
General