• DO NOT short circuit, puncture, or disassemble
• DO NOT attempt to recharge
• NEVER dispose of lithium batteries in a fire, or in any way expose lithium
batteries to excessive heat
• Batteries may explode if disassembled, crushed, recharged, or exposed to
high temperatures
• Avoid mechanical or electrical abuse
• Prior to use, inspect all batteries for cracks, leakage, or bulging
• NEVER install a defective battery in the DBAL-I
2
• DO NOT install battery incorrectly
• Store at room temperature
• Refer to applicable federal, state, and local laws and regulations for proper
disposal of the batteries
WARNING
Make sure the Activation Mode Selector Switch is in the
OFF position before inspecting the Exit Port Lenses of the DBAL-I
2
.
WARNING
If the Activation Selector Switch is not in the OFF position, the laser can be
inadvertently activated by depressing the fire button on the top of the housing.
WARNING
If a laser borelight is used to boresight the DBAL-I
2
, be sure to remove the
borelight from the weapon prior to firing.
5
To Next Page
Loading...
Need help?
General