THOR 103
STEL s.r.l. – Via del Progresso n° 59 – 36020
Loc. Castegnero (VICENZA) - ITALY
TEL. +39 444 639525 (central.) – +39 444 639682 (comm.)
FAX +39 444 639641 – E-mail: stel @ stelgroup.it
http: www.stelgroup.it
12.0 SERVICE
12.1 INTRODUCTION
THIS SECTION DESRIBES BASIC MAINTENANCE PROCEDURES PERFORMABLE BY
OPERATING PERSONNEL.NO OTHER ADJUSTMENTS OR REPAIRS ARE TO BE AT-
TEMPTED BY OTHER THAN PROPERLY TRAINED PERSONEEL.
WARNING
Frequently review the important safety precautions at the front of this Manual. Be sure
the operator is equipped with proper gloves,clothing, eye and ear potection.make sure
no part of the operator’s body comes into contact with the work-piece while the torch is
actived.
CAUTION
Sparks from the cutting process can cause damage to coated, painted, and other surfaces
such as glass, plastic and metal.
NOTE
Handle torch leads with care and protect them from damage.
12.2 GENERAL TORCH MAINTENUACE
A. Cleanin Torch
WARNINGS
Disconnect primary power to the system before dissasembling the torch or torch leads.
DO NOT touch any internal torch parts while the AC indicator light of the power supply
is ON.
CAUTION
Dry th etorch thoroughly before reinstalling.
Common Operating faults
1. Insufficient penetration
ENGLISH
TECHNICAL
DESCRIPTION
THOR 103
STEL s.r.l. – Via del Progresso n° 59 – 36020
Loc. Castegnero (VICENZA) - ITALY
TEL. +39 444 639525 (central.) – +39 444 639682 (comm.)
FAX +39 444 639641 – E-mail: stel @ stelgroup.it
http: www.stelgroup.it
12.0 SERVICE
12.1 INTRODUCTION
THIS SECTION DESRIBES BASIC MAINTENANCE PROCEDURES PERFORMABLE BY
OPERATING PERSONNEL.NO OTHER ADJUSTMENTS OR REPAIRS ARE TO BE AT-
TEMPTED BY OTHER THAN PROPERLY TRAINED PERSONEEL.
WARNING
Frequently review the important safety precautions at the front of this Manual. Be sure
the operator is equipped with proper gloves,clothing, eye and ear potection.make sure
no part of the operator’s body comes into contact with the work-piece while the torch is
actived.
CAUTION
Sparks from the cutting process can cause damage to coated, painted, and other surfaces
such as glass, plastic and metal.
NOTE
Handle torch leads with care and protect them from damage.
12.2 GENERAL TORCH MAINTENUACE
A. Cleanin Torch
WARNINGS
Disconnect primary power to the system before dissasembling the torch or torch leads.
DO NOT touch any internal torch parts while the AC indicator light of the power supply
is ON.
CAUTION
Dry th etorch thoroughly before reinstalling.
Common Operating faults
1. Insufficient penetration
ENGLISH
TECHNICAL
DESCRIPTION
To Next Page
Loading...
