INSSBF0708
‘‘SBF’’ & “SPBF” series
Bathroom fan
Models: SBF050 – SBF070 – SBF090 – SBF120 – SPBF050 – SPBF070
Before installing and operating this product, the user and/or installer must read, understand and follow these instructions and keep them handy
for future reference. If these instructions are not followed, the warranty will be considered null and void and the manufacturer deems no further
responsibility for this product.
This product must be installed by a qualified person and connected by a certified electrician, according to the electrical and building codes
effective in your region.
The following instructions must be adhered to in order to avoid personal injuries or property damages, serious injuries and potentially fatal electric
shocks.
Switch off the power at the circuit breaker/fuse before installing, repairing and cleaning the unit.
Make sure the unit is appropriate for the intended use (if needed, refer to the product catalog or a representative).
If the installer or the user modifies the unit, they will be held responsible for any damage resulting from this modification and the ETL certification
could be void.
This unit must not be installed in wet locations such as, but not limited to, a shower.
When cutting or drilling into a wall or ceiling, do not damage electrical wiring and other hidden utilities.
To ensure proper air exhaust and to reduce the risk of fire, make sure all exhaust ducts lead outside. Do not exhaust air into walls, ceilings, attics,
crawl spaces or garages.
Use a specially designed dimmer to control fan speed.
Sufficient air is needed for proper combustion and exhausting of gases to prevent back drafting.
For general ventilating use only. Do not use to exhaust hazardous or explosive materials and vapours.
WARNING WARNING WARNING WARNING
Installation guide
To Next Page
General