-4-
2.0 Before using your compressor
When you have unpacked your compressor, kindly check carefully that the product is
without defects and that nothing is missing. Kindly contact your STENHØJ distributor
if you should find defects .
Stationary compressor units must be mounted on vibration dampers. Connection to
mains supply always to be carried out by STENHØJ service engineer or authorized
electrician.
2.1 Safety precautions
Control of electric cable
Isolation of electric cable must not have fissures or other defects. If in doubt, contact
your STENHØJ distributor. If an extension cable is required, this must as a minimum
be of same dimension as cable on compressor.
Voltage, current and circuit breaker
Check whether voltage and current of compressor are in accordance with voltage
and current of mains supply. Furthermore, check whether correct main fuses are
used.
WARNING
Never dismantle safety valves or other compressor parts when pressure is on.
The high air receiver pressure might make parts projectile!
3.0 Function
3.1 Function
The compressor unit compresses atmospheric air to a high pressure via the pump
unit on the compressor. The compressed air is then stocked in the air receiver. The
high pressure is used as a propellant.
3.2 Usage
The compressor unit is used primarily as a propellant for air-operated tools; e.g. nut
tighteners, grinders, power drills, scutchers, paint guns, blow guns, sand blast ma-
chines etc. The compressor unit can also be used to operate various production
plants and machines. If in doubt about usage, please contact your STENHØJ dis-
tributor.
It is of the utmost importance that you when using the compressor are aware of its
capacity in relation to the connected air-operated tool. The compressor unit must
match the consumption, otherwise there is a risk that the compressor is overloaded.
To Next Page
Loading...