-5-
3.3 Limitations
Do not use compressed air directly as breathing matter. If you require air in such a
quality, kindly contact your STENHØJ distributor. If you have any questions in this
regard, please contact your STENHØJ distributor.
IMPORTANT
Never direct outlet air towards human beings or animals.
4.0 Operation instructions
4.1 Where to place the compressor unit
The compressor unit can be placed any place dry and frost-proof. We recommend
that it is placed in a cool room.
If the unit is placed near a wall it must be placed with flywheel towards the wall. Dis-
tance from wall to belt guard min. 400 mm. Distance from unit to ceiling min. 500
mm.
4.2 Temperature
Place unit in as cool a room as possible.
The surrounding temperature to be in the area from +5 C to +20 C measured at in-
take of refrigerated air.
If placed outdoors the compressor must be protected agains snow, rain and cold.
Do not place compressor outdoors if climate is very cold, as frost might cause start-
ing problems.
4.3 Start/stop-function
The compressor unit must be connected to a motor starter. If not, please contact
your STENHØJ service engineer or an electrician.
Start compressor by turning grey button on pressure switch to AUTO. When com-
pressor has reached max. pressure, the motor will stop automatically and will start
again when pressure in air receiver drops. If the compressor is not to be used for a
longer period of time, turn grey button away from AUTO.
Please check direction of rotation of flywheel the first time you use the compressor
unit. It must follow direction of red pointer on motor. If not, stop the compressor and
call your STENHØJ service engineer. Read level in oil-level glass. Oil level = ½ full
glass.
IMPORTANT
Check that max. pressure of unit is not exceeded. The white pointer in ma-
nometer must not show higher pressure than red pointer.
To Next Page
Loading...