Need help?Do you have a question about the Stenner ECON FP Series and is the answer not in the manual?
General| Brand | Stenner |
|---|---|
| Model | ECON FP Series |
| Category | Water Pump |
| Language | English |
Details the one-year warranty, exclusions, and responsibilities for parts and labor.
Outlines the 30-day return policy for factory direct purchases, including RMA process.
Instructs on reporting order discrepancies and damages within seven days of receipt.
Provides procedures for returning pumps for warranty or repair, and details service costs.
States that manual information is not for specific applications and company reserves right to change specs.
Warns about electrical shock and hazardous voltage, stressing proper installation and service.
Details risks of explosion, fire, and personal exposure, mandating safety precautions.
Covers safe chemical handling, adherence to plumbing codes, and pump's water-only evaluation.
Highlights special instructions and mandatory actions for safe operation and maintenance.
Explains the SECONDS mode for timed pump operation based on dry contact signals.
Describes the AUXILIARY mode for pump operation via 12-24 VAC/VDC signals.
Details the FLOW SWITCH mode for pump activation via dry contact from a flow switch.
Guides on calculating maximum system or well pump flow rate in gallons per minute.
Explains how to determine solution strength percentage and required dosage in parts per million.
Provides the formula to calculate the metering pump output requirement in gallons per day.
Instructs to reference a chart to confirm the selected pump's maximum output meets the requirement.
Guides on calculating the available dose time in seconds based on system flow rate.
Provides the formula to calculate the pump operating time in seconds for the SECONDS mode.
Explains how to calculate the pump operating time percentage using a provided chart.
Details how to program the pump operating mode and time percentage using control panel buttons.
Guides on calculating chemical feed duration based on water volume and flow rate for AUXILIARY mode.
Provides formula to calculate pump speed percentage for AUXILIARY mode operation.
Details how to program pump operating mode and speed percentage using control panel buttons.
Guides on calculating pump speed percentage for FLOW SWITCH mode based on output requirements.
Details how to program pump operating mode and speed percentage using control panel buttons.
Provides crucial safety guidelines for pump installation, emphasizing compliance and PPE.
Offers guidance on selecting a dry location, mounting orientation, and avoiding flooded suction.
Details how to connect signal wires for SECONDS, FLOW SWITCH, PAUSE, and AUXILIARY modes.
Covers capping wires, plugging in, standby mode, and programming pump settings.
Provides specific installation guidelines for CE pumps concerning pool areas and electrical standards.
Illustrates the pump installation setup with a water meter, showing component connections.
Guides on uncoiling, cutting, and connecting the suction/discharge lines to the pump head.
Details how to attach the weighted strainer to the suction line and suspend it in the tank.
Covers connecting the discharge line and installing the injection fitting at the point of use.
Provides steps to take the pump out of standby, prime it, and verify operation and connections.
Details risks of exposure, pinch points, hazardous pressure, and general precautions for tube replacement.
Outlines essential preparation steps before replacing the pump tube, including safety and disconnection.
Provides a step-by-step guide with illustrations for safely removing the existing pump tube.
Guides on installing the new pump tube, aligning housing, and relaxing/securing the tube.
To Next Page
