Step2 Sky Rider Up & Down Roller Coaster User Manual

SAFETY INFORMATION
• Supervise children at all times.
• Maximum child’s weight: 35 lbs. (15,88 kg.). Limit 1 rider.
• Take indoors or do not use when the temperature drops below 32°F (0°C).
CLEANING INSTRUCTIONS
General Cleaning:
• Use a 50/50 mixture of white vinegar and water.
DISPOSAL INSTRUCTIONS:
WARNING:
BURN HAZARD
• Always check the temperature of the product before
letting your children play on it.
• Remember that the product may cause burns.
• Always be aware of the sun and weather conditions,
and do not assume that the equipment is safe
because the air temperature is not very high.
WARNING:
TO AVOID SERIOUS INJURY:
• Continuous adult supervision required.
• Use only in areas free from obstructions.
• Do not use on steps or steep inclines. Do not use on or
near steps, steep inclines or raised or uneven surfaces.
• Keep away from pools or other bodies of water.
• Shoes must be worn during use.
• Allow only one rider.
• Caution children against extreme rocking action.
WARNING:
CHOKING HAZARD
Small parts. Adult assembly required.
INTENDED FOR USE BY CHILDREN FROM AGES 2 - 5 YEARS.
OBSERVE ALL STATEMENTS AND WARNINGS TO REDUCE
THE LIKELIHOOD OF SERIOUS OR FATAL INJURY.
SAVE THIS SHEET FOR FUTURE REFERENCE.
Please recycle when possible. Disposal must be in compliance with
all government regulations.
INSPECT THIS PRODUCT
BEFORE EACH
USE. TIGHTLY
SECURE CONNECTIONS AND REPLACE DAMAGED OR
WORN COMPONENTS. CONTACT THE STEP2 COMPANY
FOR REPLACEMENT PARTS.
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC
RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO
CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE
HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST
ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING
INTERFERENCE THAT MAY CAUSE UNDESIRED
OPERATION .
12/05/2023
4402
Sky Rider Up & Down
Roller Coaster
™
The Step2 Company, LLC.
10010 Aurora-Hudson Rd.
Streetsboro, OH 44241 USA
1-800-347-8372 USA & Canada Only
(330)656-0440
www.step2.com
@THESTEP2COMPANY | #STEP2KIDS
1
194992A01B

Step2 Sky Rider Up & Down Roller Coaster Specifications

General

Material	Plastic
Number of Pieces	1
Assembly Required	Yes
Weight Limit	50 pounds
Recommended Age	2-5 years
Weight	30 pounds
Item Weight	30 pounds
Maximum Weight Capacity	50 pounds
Color	Multicolor
Included Components	Track and car

Summary

Product Safety Warnings

Choking Hazard

Warning about small parts and the requirement for adult assembly.

Serious Injury Prevention

Guidelines to avoid serious injury, including supervision and safe usage areas.

Burn Hazard

Caution to check product temperature before use, as it may cause burns.

General Safety Guidelines

Supervision, maximum weight limit, and temperature considerations for safe play.

Product Maintenance and Disposal

Cleaning Instructions

How to clean the product using a mixture of white vinegar and water.

Disposal Instructions

Guidance on recycling and proper disposal according to regulations.

Pre-use Inspection

Instructions to inspect and secure components before each use.

Product Parts Identification

Component List

Lists all parts (A-R) with quantities and dimensions required for assembly.

Assembly Instructions - Part 1

Steps 1-3: Pole and Wheel Assembly

Details on assembling the pole and attaching the wheel with cap and washer.

Steps 4-5: Base and Wheel Assembly

Instructions for attaching the base unit and securing wheels with caps and washers.

Assembly Instructions - Part 2

Repeat Assembly Steps

Instruction to repeat initial assembly steps for the opposite side.

Applying Decals

Guidance on applying decals to the wheels, tracks, and propeller.

Grip Installation Tip

Note suggesting soapy water for easier installation of grips (K).

Assembly Instructions - Part 3

Assembling G and H Components

Steps showing how to snap together parts G and H for the main structure.

Repeat Steps 11-12

Instruction to repeat steps 11-12 for the other side of the assembly.

Assembly Instructions - Part 4

Connecting Track Sections

Detailed steps for connecting track segments B, C, and D to the base.

Attaching Final Component

Instructions for attaching component E to complete the main structure.