What to do if STEPCRAFT Engine power tool stops and the setting wheel lights up red?
If your STEPCRAFT Engine power tool stops during operation and the setting wheel lights up in red, it indicates that the overload protection has been triggered. To resolve this, switch off the power. Clear the working spindle before starting again. Then, switch the power back on and continue working, but reduce the load or feed rate.
Why STEPCRAFT Engine power tool cannot be switched on and the setting wheel does not light up?
If your STEPCRAFT Engine power tool cannot be switched on and the setting wheel does not light up, it could be due to a couple of reasons. First, check the power supply to ensure there is mains voltage. If the power supply is okay, then the mains fuse may be defective and require replacement.
What to do if STEPCRAFT Engine power tool stops during operation and the setting wheel does not light up?
If the STEPCRAFT Engine power tool stops during operation and the setting wheel does not light up, it might be due to a mains failure. You should check the mains back-up fuses.
Why STEPCRAFT Engine power tool setting wheel lights up blue and it cannot be switched on?
If your STEPCRAFT Engine power tool cannot be switched on and the setting wheel lights up in blue, the carbon brushes are likely worn. Take the power tool to the STEPCRAFT customer service.
Why my STEPCRAFT MM-1000 Tools machine cannot be switched on?
There are several reasons why your STEPCRAFT Tools machine might not be switching on: * **No mains voltage:** Check the power supply. * **Mains fuse defective:** Replace the fuse. * **Carbon brushes worn:** In this case, take the machine to a STEPCRAFT customer service shop.
General| Feed Rate | up to 5000 mm/min |
|---|---|
| Repetition Accuracy | ± 0.05 mm |
| Resolution | 0.01 mm |
| Spindle Power | 800 W |
| Control Software | STEPCRAFT CNC Software |
| Power Supply | 230 V / 50-60 Hz |
| Spindle Speed | up to 24, 000 RPM (depending on spindle) |
To Next Page
