What to do if STEPCRAFT Engine power tool stops and the setting wheel lights up red?
If your STEPCRAFT Engine power tool stops during operation and the setting wheel lights up in red, it indicates that the overload protection has been triggered. To resolve this, switch off the power. Clear the working spindle before starting again. Then, switch the power back on and continue working, but reduce the load or feed rate.
Why STEPCRAFT Engine power tool cannot be switched on and the setting wheel does not light up?
If your STEPCRAFT Engine power tool cannot be switched on and the setting wheel does not light up, it could be due to a couple of reasons. First, check the power supply to ensure there is mains voltage. If the power supply is okay, then the mains fuse may be defective and require replacement.
General| Feed Rate | up to 5000 mm/min |
|---|---|
| Repetition Accuracy | ± 0.05 mm |
| Resolution | 0.01 mm |
| Spindle Power | 800 W |
| Control Software | STEPCRAFT CNC Software |
| Power Supply | 230 V / 50-60 Hz |
| Spindle Speed | up to 24, 000 RPM (depending on spindle) |
To Next Page
