Stephill SE6000D4 - Operating Instructions; Pre-Starts Checks; Check Oil Level - How to; Adding Engine Oil

SSD6000-SSD6000S-SE6000D4
13
Before any attempt to start the generator please follow these important guidelines.
It is recommended to check the oil level BEFORE EVERY START OPERATION - Ref. Fig.9.
● Make sure the generator is on level ground.
● Remove the (either side of the engine) oil dipstick (1) from the engine and wipe with a clean cloth.
● Fully reinsert the dipstick and hand tighten.
Fig.9
Operating Instructions
Adding Engine Oil
● Remove the oil dipstick from the engine. The oil level should be between the upper (2) and lower (3) lines
on the dipstick.
Add oil If the level is low. Do not fill past the high mark on the dipstick (2). WARNING - NEVER overfill the
engine with oil. Engine damage can occur.
Refer to engine owners handbook supplied with each generator for oil specification, viscosity and typical
capacity. Alternatively navigate to the Service section at
STEPHILL GENERATORS LTD STRESS THAT THE ULTIMATE RESPONSIBILTY FOR THE
SAFE USE OF THE GENERATOR RESTS WITH THE USER.
Check Oil Level - How to
● Reinsert the oil dipstick into the crankcase (4) and turn clockwise for one half revolution to engage the first
thread into the crankcase opening - Do not screw in .
Pre-start Checks
www.stephill-generators.co.uk