What to do if the burner is in a lockout condition on Stepp SMT Industrial Equipment?
If the burner in your Stepp Industrial Equipment is in a “lock out” condition, try turning the main power switch “off” and then “on” again to reset the system. Additionally, inspect the photoelectric eye for a dirty lens and ensure it's functioning correctly.
Why does the burner light but then go out on my Stepp Industrial Equipment?
If the burner in your Stepp Industrial Equipment lights but then goes out, verify the fuel supply to the burner. Check the condition of the fuel pump drive coupling, bleed the system, and inspect the electrode condition and adjustment. Also, check the function of the Ignition Transformer.
How to troubleshoot no heat in Stepp SMT Industrial Equipment?
To address no heat or a lack of heat in your Stepp Industrial Equipment, start by checking that the power switch is on, the circuit breaker hasn't tripped, and the engine is running. Ensure the thermostat is set to the material manufacturer's recommendations. Also, check for power on the #3 terminal of the thermostat, inspect for damaged or incorrect wiring, and verify the ribbon cable is correctly connected between the thermostat and LCD display. It's also worth verifying that 12.6 volts are showing as “1” on the left side of the display. If the burner and "call for heat" light don't function, consider replacing the thermostat. Check the “Call for Heat” light bulb condition. Calibrate the thermostat according to instructions. Check for proper burner adjustments. Finally, verify proper fue...
Overview of the Stepp SMT Mini Tanker and manual's purpose.
Details the manufacturer's warranty coverage, exclusions, and disclaimers.
How to claim warranty, dealer vs. factory repair, and owner duties.
Critical safety guidelines before operating the equipment.
Instructions for burner operation and pumping system usage.
Steps for properly shutting down and flushing the system.
Guidelines for performing scheduled maintenance and recording service.
Procedures for fuel filter replacement, brush inspection, and torque specs.
Diagnosing and resolving issues related to the diesel burner's heat output.
Troubleshooting specific components like controllers, sensors, and valves.
List of replacement parts for the diesel burner assembly and control system.
Replacement parts for filters, valves, chassis, brakes, and axles.
Guide to programming the Watlow EZ-Zone PM temperature controller.
Steps for navigating menus and setting controller parameters.
Electrical wiring diagram with component labels.
Comprehensive safety data for UNIVIS N 32 hydraulic fluid.
Information pertaining to the operation and maintenance of the equipment's engine.
Information regarding the tires on the equipment.
General| Brand | Stepp |
|---|---|
| Model | SMT series |
| Category | Industrial Equipment |
| Language | English |
To Next Page
