Need help?Do you have a question about the Sterling Trucks L8500 and is the answer not in the manual?
Provides torque values for U.S. customary and metric thread fasteners.
Visually inspects drive belts for glazing, ply separation, cracks, and other damage.
Provides procedures for replacing the air cleaner element based on air restriction.
Checks tightness of alternator bracket fasteners, belt tension, and electrical connections.
Instructs on lubricating the clutch release bearing with high-temperature grease.
Details the procedure for changing Allison transmission fluid and filters.
Describes changing manual transmission oil and cleaning magnetic plugs.
Details inspection procedures for Fontaine and Holland fifth wheels.
Provides instructions for lubricating fifth wheel components after inspection.
Details inspections for front, rear, and air suspension components.
Explains how to lubricate knuckle pin assemblies for Dana Spicer and Meritor axles.
Details how to inspect tie-rod ends for wear and lubricate grease fittings.
Describes the procedure for checking vehicle toe-in using a trammel bar.
Details how to check axle breather cleanliness and lubricant level for Meritor and Dana Spicer axles.
Provides procedures for changing axle lubricant, replacing oil filters, and cleaning magnetic strainers.
Explains how to check wheel and rim nut torque using a specific sequence.
Details how to inspect U-joints, slip joints, yokes, and driveshaft tubes for wear.
Provides instructions for lubricating U-joints and slip joint splines with grease.
Inspects exhaust system components for leakage, wear, or damage.
Details inspection of wiring, connectors, relays, and computer units in the chassis and cab.
Covers preliminary checks for the air conditioning system, including pulley and belt inspection.
General| Brand | Sterling Trucks |
|---|---|
| Model | L8500 |
| Category | Trucks |
| Language | English |
To Next Page