To Next Page

To Previous Page

252

• Walk, never run. Keep all parts of your body away from any moving part.

• Never run the product without the proper equipment attached.

• Do not modify the product in any way or use parts and accessories that are not

recommended by the manufacturer.

If the product is dropped, su ers heavy impact or begins to

vibrate abnormally, immediately stop the product and

inspect for damage or identify the cause of the vibration. Any

damage should be properly repaired or replace by an

authorized service centre.

• To reduce the risk of injury associated with contacting rotating parts, always stop the

machine, remove the battery pack, and make sure all moving parts have stopped:

- before cleaning or clearing a blockage

- when leaving the product unattended

- before installing or removing attachments

- before checking, maintaining or working on the product

- if the machine starts to vibrate abnormally (inspect immediately)

Trimming : Illustration

4.2

NOTE: Try to keep the cutting device angled at approximately 15° to the cutting surface.

1. Cut and remove branches exceeding the cutting capacity of this product using a proper pruner before

operation.

2. Move the cutting device lightly through the cutting surface in a sweeping motion following the shape

of the hedge or shrub.

3. A slight tilt downwards of the cutting device in the direction of motion is recommended for optimum

cutting performance.

4. Do not to rush and do not attempt to cut too much with one stroke of the cutting device.

5. First cut both sides from the bottom cutting upwards to the top. This will prevent any of the trimmings

falling into the path of the area still to be cut .

6. After cutting the sides proceed to the top. Try to keep the cutting device angled at approximately 15°

to the cutting surface.

7. Cut in a number of stages if the area being cut is particularly long to achieve a better result; smaller

trimmings will allow for easy composting.

NOTE : When shaping it is advisable to achieve a trapezoidal

shape. A trapezoidal cut corresponds to the natural growth of

plants and results in optimal hedge growth, as it will expose

more light to the lower end of the hedge.

8. Lubricate the internal surfaces of the blade if the cutting device overheats during operation.

STERWINS 20 VHT2-50.1 User Manual

Questions and Answers: