STERWINS 250 TP-3 - Specific Functions; Transportation; Wintering; Storage

190
FR
ES
PT
IT
EL
PL
RU
KZ
UA
RO
EN
16
FR
ES
PT
IT
EL
PL
RU
KZ
UA
RO
EN
Interface :
• Power On : If lit, the pressure control unit has been powered and is ready for
operation. The pump is not running.
• Pump On : If lit, the pump is operating. A line of the discharged liquid is
opened.
• Failure : If lit, the pressure control has detected a fault. In that case, please refer
to "Troubleshooting" chapter.
• Restart : To restart the pump after resolving a failure, reset the pressure control
unit by pressing this button.
5. TRANSPORTATION
5.1 TRANSPORT THE MACHINE
CAUTION In order to prevent accidents or injuries,
keep in mind the weight of the appliance during transport
(see Technical Data).
Protect the product from any heavy impact or strong vibrations which may occur during
6. WINTERING
Illustration
5.1
to
5.3
Swit
ty the pump.
Follow all instructions given on chapter storage below.
7. STORAGE
7.1 STORE THE MACHINE
The instructions mentioned in the maintenance section must be carried out before any storage.
Illustration
5.1
to
5.3
• Completely drain the pump, allow it to dry and put back the two connector caps.
• Clean the product, filters and accessories
• Store the unit and its accessories in a frost-free place.
• The unit should always be stored in a clean, dry, ventilated place out of the reach of children. Ideally, the
temperature of the room in which the device is stored should be between 4 and 24°C.
• We recommend that you store the unit in an upright position, in its original package.
transportation in vehicles. If you want to transport the appliance on a vehicle secure it from slipping
or vibrating. Secure the product to prevent it from slipping or falling over.
15
FR
ES
PT
IT
EL
PL
RU
KZ
UA
RO
EN
to vibrate abnormally, immediately stop the product and
inspect for damage or identify the cause of the vibration.
Any damage should be properly repaired or replace by an
authorized service center.
Operate the pump
• In order to prevent dry-running and overheating of the machine, always make sure that the suction
hose is immersed under water.
• The motor is protected against overheating by an integrated thermostat. In the event of overheating,
the thermostat will automatically switch o the pump. The pump will automatically restart after it has
cooled down.
Stop the pump
• To reduce the risk of injury, always stop the machine :
- before cleaning or clearing a blockage
- before installing or removing attachments
- before checking, maintaining or working on the product
- if the machine starts to vibrate abnormally (inspect
immediately).
There is no specic function about this product.
4.5 SPECIFIC FUNCTIONS