STERWINS 3276005711761 - Page 202

202
FR
ES
PT
IT
EL
PL
RU
KZ
UA
RO
EN
16
FR
ES
PT
IT
EL
PL
RU
KZ
UA
RO
EN
Interface :
• Power On : If lit, the pressure control unit has been powered and is ready for
operation. The pump is not running.
• Pump On : If lit, the pump is operating. A line of the discharged liquid is
opened.
• Failure : If lit, the pressure control has detected a fault. In that case, please refer
to "Troubleshooting" chapter.
• Restart : To restart the pump after resolving a failure, reset the pressure control
unit by pressing this button.
5. TRANSPORTATION
5.1 TRANSPORT THE MACHINE
CAUTION In order to prevent accidents or injuries,
keep in mind the weight of the appliance during transport
(see Technical Data).
Always lift and carry the pump with the carrying handle. Protect the product from any heavy impact
or strong vibrations which may occur during transportation in vehicles. If you want to transport the
appliance on a vehicle secure it from slipping or vibrating. Secure the product to prevent it from slipping
or falling over.
6. WINTERING
Illustration
5.1
to
5.3
Switch o and empty the pump.
Follow all instructions given on chapter storage below.
7. STORAGE
7.1 STORE THE MACHINE
The instructions mentioned in the maintenance section must be carried out before any storage.
Illustration
5.1
to
5.3
• Completely drain the pump, allow it to dry and put back the two connector caps.
• Clean the product, filters and accessories
• Store the unit and its accessories in a frost-free place.
• The unit should always be stored in a clean, dry, ventilated place out of the reach of children. Ideally, the
temperature of the room in which the device is stored should be between 4 and 24°C.
• We recommend that you store the unit in an upright position, in its original package.
17
FR
ES
PT
IT
EL
PL
RU
KZ
UA
RO
EN
8. MAINTENANCE
or serious injury. Switch the product before adjusting,
inspecting, cleaning or storing the product.
8.1 CLEANING
Illustration
4.1
to
4.6
1. Disconnect the pump
2. Unscrew the discharge connection
3. Clean the discharge part of the pump with clean water
4. Check the integrity of the electrical cable.
8.2 SERVICE
• Have your product serviced by a qualified repair person using only identical replacement parts. This will
ensure that the safety of the product is maintained.
• Have the product checked by a qualified professional and repaired, if necessary, before you use it again.