STERWINS 40VLM2-46SP.1 - Mower Installation and Preparation; Preparation Before Use

200
FR
ES
PT
IT
EL
PL
RU
KZ
UA
RO
EN
Side ejection : illustration
2.5 A
In case of heavy mowing work, you can use the side discharge feature. Lift the rear discharge
door, move out the grassbag, and put the rear grass shutter in place. Then lift the security side
row grass cover, put on the side ejection guide and release the side row grass cover to lock the
side discharge guide.
Mulching : illustration
2.5 B
Mulching is a lawn mowing method that consists of cutting small layers of grass very regularly
to fertilize the soil. Lift the rear discharge door and remove the grass collection box and the
grass shutter. Only cut a few centimeters on each pass and let the grass fall in front of you as
you mow.
Installing/Removing the battery pack :illustration
4.1
WARNING : Make sure the latch on the bottom of the battery pack snaps in place and the
battery pack is fully seated and secure in the product’s battery docking port before beginning
operation. Failure to securely seat the battery pack could cause the battery pack to fall out,
resulting in serious personal injury.
To install : Raise the battery cover, and insert the battery pack. Push battery pack into the
bottom of the battery cover, and make sure that battery pack is secured in the product before
beginning operation. Close battery cover.
4.3 PREPARATION
Wear safety equipement : illustration
3.1
Before using the product, make sure to put on the following protective equipement :
→ Safety glasses
→ Face mask
→ Earmus
→ Protective gloves
→ Protective overall
→ Safety boots
Adjust the handle height : illustration
3.2
Adjust the lower handle to the correct position for comfortable height, by aligning the line on
end of the lower handle with one of the four lines on the mower body. Fit the quick clips through
the lower handle, then tighten it.
WARNING! DO NOT USE THE PRODUCT WITH ANY OTHER HANDLE
CONFIGURATIONS THAN THOSE SHOWN IN THE INSTALLATION
CHAPTER.