7. MAINTENANCE
DANGER! Risk of injury due to electric shock.
Warning! Always remove the plug from the socket before servicing,
cleaning or storage.
If the pump becomes clogged, connect the discharge line to the water line and disconnect
the suction hose. Open the water line than switch on the pump several times for approx. two
seconds. This should solve most clog-related problems.
Servicing
• Open the water drain screw , empty the pump completely and allow it to dry.
• Store the pump so that it is protected from frost.
• After long periods of stoppage, make sure the rotor turns correctly by briefly switching the
pump on and off.
Storage
119
EN
20151208 SPECIFICATIONS 250 TP-3 EXE.indd 119 08/12/15 16:21
4
To Next Page
Loading...
